2001 Durango
-
Upload
christian-icaza-samaniego -
Category
Documents
-
view
215 -
download
0
Transcript of 2001 Durango
-
7/27/2019 2001 Durango
1/2
Dodge Dur ango 2001
WWW.WIREMAGIC.COM
Wire/F unction Colour L ocation / Descr iptio Polar ity
Installation type: Remote start / security / GPS
Pink/black or Red Ignition harness +12 VOLTS
Dk.blue Ignition harness +IGNITION
Green/red (4.7L engine only) Ignition harness +IGNITION 2
Black/orange Ignition harness +ACCESSORY
Green Ignition harness +ACCESSORY 2
Yellow Ignition harness +STARTER
Black/gray At coil or PCM*` ACTACH
Orange/violet In driver's kickpanel** REV POLLOCK
Pink/violet In driver's kickpanel** REV POLUNLOCK
Yellow*** At courtesy light under dashpanel -DOORPIN
Tan/black 16 pin connector Below fuseblock -TRUNK PIN Tan/red In driver's kickpanel -DRIVER DOOR L ATCH
Lt.green/orange**** In driver's kickpanel -FACTORY ARM
Lt.green/orange**** In driver's kickpanel -FACTORY DISARM
White/tan At switch above brake pedal +BRAKESWITCH
Black/yellow At light switch harness +PARKLIGHTS
White/black At plug on handbrake lever -HAND BRAKE
Black/red At steering column -HORN
Lt.blue At main window switch REV POLDRIVER WINDOW UP
White At main window switch REV POLDRIVER WINDOW DOWN
Purple/white At main window switch REV POLPASSENGER WINDOW UP
Brown/white At main window switch REV POLPASSENGER WINDOW DOWN Dk.blue/white At main window switch REV POLLEFT REAR WINDOW UP
Red/black At main window switch REV POLLEFT REAR WINDOW DOWN
Gray/black At main window switch REV POLRIGHT REAR WINDOW UP
Green/white At main window switch REV POLRIGHT REAR WINDOW DOWN
Lt.green At light switch harness +HEADLIGHTS
Violet/black In driver's kickpanel +REVERSE LIGHTS
White/orange Pin-27 on C2 connector at PCM***** 8000ppmVSS WIRE
Lt.blue Ignition harness -KEY SENSE
PLEASE NOTE: This vehicle is equipped with a SENTRY-KEY IMMOBILIZER system. Please refer to the ALARM diagram beforeany remote start installation.* On the 5.9L the coil is located on the front of the engine, PCM is located in front of the Washer fluid reservoir. The 4.7Lengine has a coil for each cylinder. Use the TAN colored wire at any of the coils and set your remote starter for 1 cylinder.(see exploded views)** If equipped with keyless entry, these wires will be positive pulse. Models equipped with factory alarm have a single wire toperform all doorlock and security functions. See the DOORLOCK diagram.*** You can also find the doorpin wires on a BLACK plug on the left side of the brake pedal. BLACK/BLUE for the driver's door,TAN/RED for all the other doors and TAN/BLACK for the hatch. The factory alarm disarm LT.GREEN/ORANGE can also be foundon the plug.
Vehicle note:
Thursday, January 17, 2002 Page 1 of 2
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting toit. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumesabsolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and
Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in an other wa . The information su lied is a uide onl . Co ri ht 1998-2001 Wirema ic.com Cor oration. All ri hts reserved.
-
7/27/2019 2001 Durango
2/2
Dodge Dur ango 2001
WWW.WIREMAGIC.COM
**** Use a ground pulse through a 1500-ohm resistor to disarm factory security (a second pulse will unlock the doors). Aground pulse through a 620-ohm resistor will arm security and lock the doors. The LT.GREEN/ORANGE is found in a BLACK
connector on the left side of the brake pedal.***** Located on the right front inner fender.
Thursday, January 17, 2002 Page 2 of 2
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting toit. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumesabsolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and
Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in an other wa . The information su lied is a uide onl . Co ri ht 1998-2001 Wirema ic.com Cor oration. All ri hts reserved.