Anuncio de Pared (Letrero de Negocio)

7/29/2019 Anuncio de Pared (Letrero de Negocio)

1/27

Project: Hanging Sign Page 1 of 27

HANGING SIGN

NOTE: The measurements within this text and 2D documentation are given both in millimeters

and inches (in brackets). This website is based on ISO measurement unit system, which is the

international standard. I apologize to the people who use other measurement units; but I believe thatmeasurements given in millimeters and inches should be adequate for everyone who would like to

build this project.

Besides that, on todays Internet it is easy to purchase the ruler that contains all the

measurement units and thus overcome the difficulties of any kind.

The items are made out of the following material:

- sheet metal, thickness 1,2 mm Sign Table (item 10);- rectangular steel band, dimensions 20 x 3 mm Frame (item 1), Lower Support (item 2),

Circle (item 3), Big Spiral (item 4), Small Spiral (item 5);

- rectangular steel band, dimensions 32 x 6 mm Vertical Support (item 6), Wall Support (item7);- the rods with circular cross section D4 mm Table Holder (item 8), Hook (item 9).

Make the components as given on pictures
http://localhost/var/www/apps/conversion/tmp/scratch_2/WWW.CRAFTSMANSPACE.COM


2/27

Pro

Parts List


3/27

Pro

2D Documentation


4/27

Pro


5/27

Pro


6/27

Pro


7/27

Pro


8/27

Pro


9/27

Pro


10/27

Proj


11/27

Proj


12/27

Proj


13/27

Proj


14/27

Proj


15/27


Assemblage Instruction

1. Weld the Wall Support (item 7) to the Vertical Support (item 6).


16/27


2. Weld the Frame (item 1) to the previously made assembly.


17/27


3. Weld the Big Spiral (item 4) to the assembly made in step 2.


18/27



19/27


4. Weld the Small Spiral (item 5) to the assembly made in step 3.


20/27


5. Weld the Circle (item 3) to the assembly made in step 4.


21/27


6. Weld the Lower Support (item 2) to the assembly made in step 5.


22/27



23/27


Note: You should weld BOTH SIDES of all the assemblies.


24/27


7. Set the Hooks (item 9) to the Sign Table (item 10).


25/27


8. Pull the Table Holder (item 8) through the Hook (item 9) and then weld it to the assembly made in step 6


26/27


9. Fasten the whole construction to the wall with standard parts Fischer (item 11) and Hexagon BoltM8 x 70 mm (item 12).


27/27


Anuncio de Pared (Letrero de Negocio)

Documents

Transcript of Anuncio de Pared (Letrero de Negocio)