DAFTAR PUSTAKA

Abrian, A. 2010. Modul Teknik Pengecoran dan Peleburan Logam.Teknik Metalurgi

UNJANI.

Amos, A.A., Julius, O., dkk. 2014. Effects of Thermomechanical Treatment on The

Chemical and Mechanical Properties of Al-Cu Alloy. Internastional Journal of

Material. Vol 2 No.1 PP : 1-11

ASM. Handbook . 1984.

ASTM E 112-96.2004.

Bahtiar., Soemarjdi, L. 2012. Pengaruh Tempratur Tuang dan Kandungan Silicon

Terhadap Nilai Kekerasan Paduan Al-Si. Jurnal Mekanikal. Vol 3 No.2 :311-

315

Kasprzak.W., Sahoo, M., dkk. 2009. The Effect of Melt Temperature and the Cooling

Rate on the Microstructure of The Al-20%Si Alloy. International Journal of

Metalcasting.

Li M. and Zinkle S.J. 2012. Physical and Mechanical Properties of Copper and Copper

Alloys. In: Konings R.J.M., (ed.) Comprehensive Nuclear Materials, volume 4,

pp. 667-690 Amsterdam: Elsevier.

Marisa Di Sabatino. 2005. Fluidity of Foundry Aluminium Alloys

Septian, R. 2011. Porositas Penyusutan Paduan Duralumin Pengecoran Sistem Vakum.

Skripsi. Jakarta :Universitas Indonesia

Siswanto, R. 2011. Pengaruh Temperatur dan Waktu Peleburan Pengecoran Tuang

Terhadap Struktur Mikro Paduan Al-21%Mg. Media Sains. Volume 3 Nomer 1

Suprapto,W. 2012. The Fluidity Characteristics of Liquid Duralumin by Piece Test

Methode on Permanent Mold in Low Pressure. Jurnal Rekayasa Mesin. Vol 3

No 1: 268-275

Surdia, T. dan Cijiiwa K. 1996. Teknik Pengecoran Logam. PT Pradnya Paramita,

Jakarta.

Vort, V., George.F.1999. Metallography Principle and Practice. New York. McGraw-

Hill, c1984.

Van Vlack, H., Lawrence, dan Djaprie, S.,1983,” Ilmu dan Teknologi Bahan “,

Erlangga, Jakarta, pp.225-231

Yuswono. 2002. Pengaruh Kandungan Inklusi dan Porositas terhadap Kegagalan

Produk Kabel Tembaga Melalui Pengerjaan Drawing Kawat.Jurnal Pusat

Penelitian Metalurgi (P2M) –LIPI