instalacion 3M

download instalacion 3M

of 6

Transcript of instalacion 3M

  • 7/27/2019 instalacion 3M

    1/6

    June 2009

    78-8140-2304-6-C

    3M One Step Closure, Small with Washer (OSCW-SW)

    for Wireless Applications

    Instructions

    3

  • 7/27/2019 instalacion 3M

    2/6

    78-8140-2304-6-C2

    Range A B

    With

    Washer

    Without

    Washer

  • 7/27/2019 instalacion 3M

    3/6

    378-8140-2304-6-C

    1.0 Kit Contents

    A

    B

    C

    D

    E

    a) 3M One Step Closure, SmallOSCW-SW

    b) Cable tie

    c) Plastic washer

    d) Rubber washer, thick

    e) Rubber washer, thin

    f) Instruction manual

    2.0 Installation

    2.1 Place washer as shown before coupling to antenna.

    2.2 Cut along the dotted line to remove the measuringtape located on page 2 of the instructions. Measure

    the jumper cable. "A" indicates the need for awasher and "B" indicates that no washer is needed.

  • 7/27/2019 instalacion 3M

    4/6

    78-8140-2304-6-C4

    2.3 If a washer is needed, cut the washer along thegroove.

    2.4 Place the washer onto the jumper cable.

    2.5 Install the protector on the connector of antennaand cable, arrow on the surface points to antenna.

  • 7/27/2019 instalacion 3M

    5/6

    578-8140-2304-6-C

    2.6 Make sure the smooth neck of connector is outsideof the ladder and the other part from the screwthread is inside of the ladder, under the protection

    of the gel.

    2.7 Make sure the washer is in the gap at the entrance

    of jumper cable during installation.

    2.8 Place the cable tie through the square holes.

    2.9 Close the two halves of the closure and fasten

    the latch.

    2.10 Tighten the cable tie.

    Note: Do not rotate closure on cable after installationas this may impair the sealing material.

  • 7/27/2019 instalacion 3M

    6/6

    3M is a trademark of 3M Company.

    Important Notice

    All statements, technical information, and recommendations related to 3Ms products are based on information believed to be reliable,

    but the accuracy or completeness is not guaranteed.Before using this product, you must evaluate it and determine if it is suitable for

    your intended application.You assume all risks and liability associated with such use.Any statements related to the product which are not

    contained in 3Ms current publications, or any contrary statements contained on your purchase order shall have no force or effect unless

    expressly agreed upon, in writing, by an authorized officer of 3M.

    Warranty; Limited Remedy; Limited Liability.

    This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase.3M MAKES NO

    OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR APARTICULAR PURPOSE.If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3Ms option,

    to replace or repair the 3M product or refund the purchase price of the 3M product.Except where prohibited by law, 3M will not be

    liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the

    legal theory asserted.

    3

    Communication Markets Division3M Telecommunications6801 River Place Blvd.Austin, TX 78726-90001-800-426-8688www.3MTelecommunications.com

    Please Recycle. Printed in USA. 3M 2009. All Rights Reserved.78-8140-2304-6-C

    "RoHS Compliant 2002/95/EC" means that the product or part("Product") does not contain any of the substances in excess of themaximum concentration values in EU Directive 2002/95/EC, asamended by Commission Decision 2005/618/EC, unless the substanceis in an application that is exempt under EU RoHS. This informationrepresents 3M's knowledge and belief, which may be based in wholeor in part on information provided by third party suppliers to 3M.

    2.11 Ensure cable exits the closure straight for 4"(102 mm).

    4" (102 mm)