Fusibles

1999-00 ELECTRICAL

Fuses & Circuit Breakers - Concorde, Intrepid, LHS & 300M

IDENTIFICATION

JUNCTION BLOCK

Fuses & Relays

The fuse block is located behind the end cover at the left side of the instrument panel. See Fig. 1 . Pull the cover straight away from the instrument panel for access to the fuses. The location and identification of fuse block fuses and relays can be found on the inside of the instrument panel end cover.

CAUTION: When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.

NOTE: Junction block may also be referred to as fuse block.

NOTE: Power Distribution Center (PDC) also contains fuses. See POWER DISTRIBUTION CENTER .

1999 Chrysler 300M

1999-00 ELECTRICAL Fuses & Circuit Breakers - Concorde, Intrepid, LHS & 300M

1999 Chrysler 300M


martes, 08 de abril de 2014 12:07:57 p.m. © 2011 Mitchell Repair Information Company, LLC. martes, 08 de abril de 2014 12:08:02 p.m. Page 1 © 2011 Mitchell Repair Information Company, LLC.

Fig. 1: Locating Junction Block Courtesy of DAIMLERCHRYSLER CORP.

1999 Chrysler 300M


martes, 08 de abril de 2014 12:07:58 p.m. © 2011 Mitchell Repair Information Company, LLC.

Fig. 2: Identifying Junction Fuses & Circuit Breakers Courtesy of DAIMLERCHRYSLER CORP.

POWER DISTRIBUTION CENTER

Fuses & Relays

CAUTION: When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.

1999 Chrysler 300M



Power Distribution Center (PDC) is located in the engine compartment. See Fig. 3 . This center contains fuses and relays for circuit that operate only under the hood. A label which identifies these components is located on the underside of the cover.

Fig. 3: Locating Power Distribution Center Courtesy of DAIMLERCHRYSLER CORP.

1999 Chrysler 300M



Fig. 4: Identifying Power Distribution Center Fuses, Connector & Relay Terminals

1999 Chrysler 300M



Courtesy of CHRYSLER CORP.

Fig. 5: Identifying Fuse Ratings & Circuits Courtesy of CHRYSLER CORP.

Relay Terminal Identification

1999 Chrysler 300M



Fig. 6: Identifying A/C Compressor Clutch Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 7: Identifying Automatic Shut Down Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 8: Identifying Engine Starter Motor Relay Terminals Courtesy of CHRYSLER CORP.

1999 Chrysler 300M



Fig. 9: Identifying Fuel Pump Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 10: Identifying High Speed Radiator Fan Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 11: Identifying Low Speed Radiator Fan Relay Terminals Courtesy of CHRYSLER CORP.

1999 Chrysler 300M



Fig. 12: Identifying Transmission Control Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 13: Identifying Wiper High/Low Relay Terminals Courtesy of CHRYSLER CORP.

Fig. 14: Identifying Wiper On/Off Relay Terminals Courtesy of CHRYSLER CORP.

1999 Chrysler 300M



Fusibles

Documents

Transcript of Fusibles